Safety of machinery – Basic concepts, general principles for design – Part 1: Basic terminology, methodology This European Standard defines basic terminology and methodology used in achieving safety of machinery. The provisions stated in this standard are intended for the designer. Pages: 33 Add To Cart
Archive | CE Standards Machinery Directive RSS feed for this section
EN ISO 12100-2:2003 +A1:2009
Safety of machinery – Basic concepts, general principles for design – Part 2: Technical principles This European Standard defines technical principles to help designers in achieving safety in the design of machinery. This European Standard is intended to be used together with EN ISO 12100-1 when considering the solution to a specific problem. The two [...]
Read full story • Comments are closed
EN 12198-1:2000+A1:2008
Safety of Machinery – Assessment and reduction of risks arising from radiation emitted by machinery – Part 1: General principles This standard deals with the emission of radiation from machinery. This European Standard gives advice to manufacturers for the construction of safe machinery, if no relevant C-type standard exists. This radiation emission may be functional [...]
Read full story • Comments are closed
EN ISO 13732-1:2008
Ergonomics of the thermal environment – Methods for the assessment of human responses to contact with surfaces – Part 1: Hot surfaces This part of ISO 13732 provides temperature threshold values for burns that occur when human skin is in contact with a hot solid surface. It also describes methods for the assessment of the [...]
Read full story • Comments are closed
EN ISO 11688-1:2009
Acoustics – Recommended practice for the design of low-noise machinery and equipment – Part 1:Planning This International Technical Report is an aid to understanding the basic concepts of noise control in machinery and equipment. The recommended practice presented here is intended to assist the designer at any design stage to control the noise of the [...]
Read full story • Comments are closed
EN ISO 11554:2008
Optics and photonics – Lasers and laser-related equipment – Test methods for laser beam power, energy and temporal characteristics This International Standard specifies test methods for determining the power and energy of continuous-wave and pulsed laser beams, as well as their temporal characteristics of pulse shape, pulse duration and pulse repetition rate. Test and evaluation [...]
Read full story • Comments are closed
ISO 11553-1:2008
Safety of machinery – Laser processing machines – Part 1: General safety requirements This part of ISO 11553 describes hazards generated by laser processing machines, as defined in 3.2, and specifies the safety requirements relating to radiation hazards and hazards generated by materials and substances. It also specifies the information to be supplied by the [...]
Read full story • Comments are closed
EN ISO 11252:2008
Lasers and laser related equipment – laser device – Minimum requirements for documentation This International Standard specifies the minimum documentation and information for marking and labelling, to be provided with laser devices (including laser diodes). The documentation is presented on two levels: as a technical data sheet (Clause 5 ) and as an instruction manual [...]
Read full story • Comments are closed
EN ISO 11200:2009
Acoustics – Noise emitted by machinery and equipment Provides brief summaries of the basic Standards for determining emission sound pressure levels from all-types of machinery and equipment, at work stations and other specified positions, and gives guidance on the process of selection of which is appropriate to any particular type. The guidance given applies only [...]
Read full story • Comments are closed
EN ISO 11145:2008
Optics and photonics – Lasers and laser related equipment – Vocabulary and symbols This International Standard defines basic terms, symbols and u nits of measurement for the field of laser technology in order to unify the terminology and to arrive at clear definitions and reproducible tests of beam parameters and laser-oriented product properties. Pages: 29
Read full story • Comments are closed
Connect
Connect with us at these channels:
